Pedal Power Generator

Bike Power Generator,green power

Pedal Power Generator,

If you are a cyclist, you know the value of winter training. But, do you know the value of your exertion? Your energy is being turned into heat by your trainer. Recapture your energy! The Bike Power Generator is the answer.

The Bike Power Generator consists of a powder coated steel trainer frame holding a permanent magnet DC generator.  Your bicycle (typical adult 27 inch wheel diameter) is mounted securely to this frame and the rear tire is positioned to turn the friction drum that has been custom fit over the generator shaft.  The amount of electrical power that can be generated by the Bike Power Generator is determined by the energy available from pedaling the bicycle. The stronger the user, the higher the production of electrical power. A well inflated tire with a smooth tread allows for maximum contact and efficiency.

How much power can a cyclist expect to produce with the Bike Power Generator?  The average person can expect to produce in the range of 150 watts sustainably, charging variably at between 10A - 16A.  The Bike Power Generator has been designed with a generator capable of handling 20A of current.  When used to charge a 12 Volt battery, this produces a maximum PEAK power output of around 275 Watts (13.6 V x 20A = 272W) or just over a third of one horsepower (One horsepower is equal to 746 Watts).One can expect the peak output only in very short bursts.

While it is possible to directly power some DC appliances such as water pumps, the Bike Power Generator is primarily designed to charge a deep cycle, 12-Volt battery or to contribute to a 12 Volt battery bank.  Most household appliances require alternating current (AC) which requires a DC to AC inverter (see our Portable Power Pack).  Certain DC appliances, such as DC lights, can be powered directly, but it is important to observe maximum voltage ratings to avoid damaging these appliances. It is usually necessary to use a voltage regulator or carefully monitor output with a voltmeter or multimeter. The output of a permanent magnet DC generator is variable - based on rpm and load.

Specification of bike power generator

1)size: 54cm×48cm×36cm

2)weight:20kgs

3)output power:150~200W

4)voltage:14.5V

5) rotating speed: 65~75 r/min

Specification of power pack(option)

1)size: 17.7cm×22.5cm×18.2cm

 2)weight:10kg

3)Power:200W

4)voltage:110~220V 50HZ

How to set up:

1)put the brace on ground

Pedal Power Generator